Page 1 of 1
swapping HD - E6400 to another
Posted:
Tue Jul 12, 2005 11:06 pmby sturoc
I have 2 E6400s: one has an HD in it. I would like to take it out and put into the other which has more upgrades in it.
Is it a simple process or are there issues ??
Posted:
Tue Jul 12, 2005 11:29 pmby greenman
no problem, did that a few times
Did the HD swap
Posted:
Mon Aug 18, 2008 4:47 amby sturoc
Well apparently there are some issues or steps to be done.
The HD which I took out of my other E6400 class. had a bunch of folders on it .
Did the swap over along with a midi card option.
The unit see's the HD but shows it many times - 7 to be exact and the floppy. all have the contents and can load it from them no problem but
I think there's a scsi issue here?
Ribbon was connected same as in other unit red strip towards front panel
Also with the 2nd midi card installed the prev or next button led is in multi mode, this is normal ?
Posted:
Mon Aug 18, 2008 9:26 amby wigworld
It sounds like a SCSI termination issue. Is termination switched on in the new machine? Check under master>setup>scsi. If it is switched off, turn it on (and vice versa). Changing the SCSI ID might help also - the Emu and hard drive need different SCSI ID's.
Yep!
Posted:
Mon Aug 18, 2008 5:54 pmby sturoc
Got it, thanks for the reminder on scsi id's.
termination normally wants to be on as per manual.