emusonacid!

so i send a wav to sample save it as a bank


then open the bank

bank name ie :bank 1

untitiled preset

no sound

yes i have read the book
the instructions are crap


i have done it once or twice and got sound

but by accident

but now i know how to save samples as a bank not to a preset

i cant get sound

i can get sound and keyboard control back if i press the sample manage button


two days man for f**k sake someone help me

its just plain stupid i just wanna put a sample in and go

thank god for software

please some one help cause this shit house is going back on ebay if i

cant even get that right every time

if fact i might burn it and post the pictures on this board


(joking)


peace

man emu is the easiest sampler ot navigate and grasp, took me all of 1-2 hours. ( and that was without using the manual)


Anyway, sounds like you are not selecting the sound in presset edit, make sure to create a preset that has the voice spread out over the whole keyboard, then just move over to the bit that says empty sample and turn the dial until you see the sample you want assigned. Now it wiill sound when u hit audition and when you send the sampler midi from your keyboard.


Then again if it has taken you 2 days even with the manual and still not worked it out, amybe you should burn it after all hehe.

i keed i keed.

sell it, use software.

it is really not that hard.

there are several threads on this forum regarding presets.

good luck

For a single sample sound:

1. record your sample, select the correct root note, 'place' it and name the sample in Sample Manage
2. If you didn't place your sample, map that sample in Preset Edit mode across your keyboard
3. Name the Preset in Preset Manage mode
3. Name your bank and save it; your sample and preset will be saved too

A preset is what you play from the keyboard (it's made up of at least one sample) so you must map/place the sample(s) within that preset.

Hope this helps,

Gilles