emusonacid!

Ive got a brand new control (with the buttons) for the Ultra series, it has the encoder board too, Both Brand new.

Have a seperate encoder too (new without the board) great if you just want to swap yours.

PM me with offers.

Thanks Paul

Forgot to mention, the board doesn't have the buttons on just the tact switches, you'll have to use you own buttons.

I messaged you about this item... What is the control board? I've never herd of it. Is it just the faceplate or something? And what's the encoder board?

Sorry about that, I don't come on here too much.
Its the board that sits behind the main front panel that holds all the tact switches and LEDs.

Its part number is AP10395/01 rev A.

Connected to it is the small board with the encoder on it.

This board is for ultras. I bought it to replace my E4 front board but its very slightly different.

Hope this helps.

I sent you another PM.

Sorry wrong part number, its PC10395 REv B with assemble numbers as pervoiusly mentioned in the ad.

Right it has a ribbon for the main digital bus (for the switches) and a line cable which goes to the encoder sub board.

The board is brand new, never fitted.

Differences are,
1, the E4 series has 7 mounting screws on the board but the ultra has 6. They are all there on the board but one is soldered over. This could be redrilled out.
2, The encoder pot used on the Ultra models is smaller with a thinner shaft so the E4 encoder knob wont fit, well it does but its loose.
Other wise they are the same. I have both E4 and ultra and have checked against both.

Thanks Paul

First £25 gets it.

bcitral wrote:First £25 gets it.

PM sent.

Sorry, its now sold off list.

The board not the MPC.