emusonacid!

Hopefully this problem has happened to others in this forum and there is a simple solution. I have quite a few banks filled with presets that I can't seem to effect with the RFX card. Any bank I load off the SIGNATURE SERIES BUNDLE is impossible to effect. I can effect any preset in a new bank I create from scratch but not presets from existing banks. Has anyone else experienced this or am I just incredibly confused here? I use the exact same steps in both cases. The only time I can hear my old presets through any effects is when I am in the Master->FX->RSetup screen. Once I leave that screen the effects are gone and the signal runs dry even if I run the preset though the bus that has the effects on it. Any ideas? I am almost ready to use my RFX card as a book end so any help for this problem would be excellent.

You need to go into your voices and change them over from classic mode to RFX mode... It's all in the manual.

Thanks for your response MindMech but that wasn't the problem. The problem was that I was in Multimode and I had not updated the current Multisetup to the RFX setup I was using so I was using the default legacy effects. I swear I read the manual! I must have missed that. Thanks! I am up and running again!