emusonacid!

looking to reboot e6400 ultra from floppy drive(v4.02)....Does anyone know the button commands to do this? (as always time not on my side), many thanks.E

What do you mean by 'reboot' ? You my want to install EOS 4.02 again ? There's no actual reboot, turn off the machine, put in the EOS floppy and turn it on, going from memory it will ask you if you want to write EOS to Flash or so, answer yes to do so or no, if answer NO then machine will boot with installed EOS. After you installed, INIT EEprom via MASTER menu (please see manual), recalibrate rotary controller, Volume. May work without doing the latter, but I always did, as recommended. If you update to 4.61 or even 4.70 you MUST load Flash Prep Disk first (see Emu website), to be able to update.