Page 1 of 1
SCSI doesn't work any more after installing internal IDE
Posted:
Mon Dec 07, 2009 11:10 pmby elprez
Hey there!
I just installed an IDE drive into my Ultra6400 and it works like a dream. However, since then my computer doesn't recognize the EMU on the SCSI-port upon booting. Does anybody know what's wrong here?
Thanks in advance
Re: SCSI doesn't work any more after installing internal IDE
Posted:
Tue Dec 08, 2009 5:33 amby kalide
Did it before ?
What worked before ? Did you have a SCSI drive ? Is termination enabled ? Is Ignore computer on SCSI ID XX enabled ?
M
Re: SCSI doesn't work any more after installing internal IDE
Posted:
Tue Dec 08, 2009 9:45 amby elprez
Sorry, I should have provided this information. Yes, it did work before. And I didn't change the settings. Termination is enabled, as well as Ignore Host on ID. I used the SCSI port to send samples to and from my PC. But since the IDE drive is installed the PC doesn't see the EMU is there. In fact it sees something is on the SCSI port but does not recognize it as the EMU any longer, which it did before.
???
Hope somebody can help me on this, thx
Re: SCSI doesn't work any more after installing internal IDE
Posted:
Thu Dec 10, 2009 4:40 amby kalide
Sounds like:
* termination problems (term on computer and on emu)
* ignore computer on scsi setting
Also double check you've not done something affecting the power - the IDE power cable on the Emu's is reversed from normal PC like connectors - so make sure the +12 off the motherboard is going to +12 on the drive, +5 and the two grounds....
M
Re: SCSI doesn't work any more after installing internal IDE
Posted:
Fri Dec 11, 2009 3:09 pmby elprez
Now it works
Don't know what was wrong because I didn't make any changes. But thanks anyway...