emusonacid!

I have two E6400 ultras (not greedy, it was more cost effective to buy a second one 2nd hand than to buy extra outputs for the first...)

I have tried to install hard drives into both, an 80meg in one and a 120meg in the other..

The sampler with EOS 4.61 works with the HD and the other, with EOS 4.50 doesnt, it will save once and never again until I format it again....

I have been told that I need to upgrade the software (which I did have on disk - only can no longer find..)

I have tried downloading a newer EOS (4.7 from here) but cant get it to work - as far as I can remember all you had to do was put the disk in and boot it up? this doesnt worka nd neither does anything else I have tried.

any help would be much appreciated, and before you ask the studio is run from an atari so i cant load a new EOS straight from a PC (although I do have access to one to download onto a disk etc)

thanks!

Steve.

(Ps I have never got my RFX to work and I dont care, ?400 wasted but I cant be bothered with the hassle!)

You need to also run the flash prep disk before (download from emu or from files section here)

Art

I thought that was only for updating from 4.10 or older? I have 4.50?...