emusonacid! legacy

by **E4kuser** » Fri Apr 25, 2008 8:04 pm

Anyone here ever taken the top off there E4K?

could do with a few pointers????

by **E4-platinum** » Sun Apr 27, 2008 9:04 am

There are nice pics in the manual.
losen the plastic cover to the display,Think you have to puch it to the right side. .under that cover is 2 small srews.after they are gone you have to losen the side panels.Then you see the oter screws that holds the panel.
hope this will help
/
Cheers

by **gcoudert** » Sun Apr 27, 2008 11:49 am

The hardest thing is to push the bl**dy front panel back in! I had to use a wall paper scraper to guid it in.

Gilles

by **plus321** » Mon Apr 28, 2008 2:28 am

Gently remove the display cover and take out the two screws. Then take off the side panels and then remove 2 or 3 screws keeping the panel attached and remove the top row of screws on the back over the jacks (it is a lot).

Be very careful when you lift up the panel. Some of the connector cables are very short. You could easily damage them if you pull too hard too fast.

by **E4kuser** » Mon Apr 28, 2008 9:51 am

i think i'll leave it,as i was going to install more memory ram,but i think i'll just leave it and sell it!

by **E4-platinum** » Tue Apr 29, 2008 8:21 am

NO!!!!!!!!
Keep that bastard

emusonacid! legacy

how do i take the top off my E4K?

how do i take the top off my E4K?