E-synth Ultra Presets, loading problems solved

For everything about the EMU sampler EXCEPT preset and cord creations.

Moderators: ezman, stu, Ole

E-synth Ultra Presets, loading problems solved

Postby analog1 » Thu May 19, 2011 8:51 pm

Hi guys
I have the E-synth Ultra with E-synth and Orbit Phatt rom, that i bought it used 2 years ago without the useful factory floppy disks or the "Ultra Production Set Backup Data" Cd rom.
After i erased my presets that was not all loaded in (255 from 499 those from the PDF file) i download the 3 presets files
    Ultra E-Synth
    Ultra Sessions
    Ultra Sessions X
from viewtopic-f=2&t=2929.php.html
I tried the Ultra E-Synth first, for restoring the original presets, but when its almost 100% loaded stays there and there is no way to complete the loading.
After reading the pdf file http://www.ezman.ukfsn.org/emusonacid/6 ... lation.pdf
Its says that i must use Utra Sessions file if i have 2 roms (E-synth-Orbit inside), i did that , then the loading was successful but there is some anarchy is the sounds, with wrong notes , octaves, effects etc.
I'm doing something wrong in the procedure ? The 2 roms are recognised and ok and i can load the raw samples.
I just copy the content of the unzip file to the floppy disk , normal copy paste with DOS format floppy disk.

Is the following files that is prescribed in the PDF, same like those from Stu ?

    "E-Synth Ultra Production Set disk"
    "E-Synth Session Factory preset disk"

I was frustrated by the fact that E-mu has not those files on the support download session , on the their site . Its a pity i think.
I was also tried to "google" my problem without success .
I will try tonight to install again properly the roms like in the procedure in the PDF and lets see tomorrow . All tips are welcome
Thank you in advance
analog1
 
Posts: 10
Joined: Tue May 19, 2009 10:00 pm

Re: E-synth Ultra Presets, loading problems solved

Postby analog1 » Sun May 22, 2011 11:42 am

Hi again

Finally i managed to load all the presets .
I put in the floppy with the E-synth ultra and instead of use load i used browse then
it was possible to see the original presets .
I loaded them one by one in the ram and then copy them to flash !
It works now i have all the original presets (from E-synth ultra rom and orbit rom ) back to life, its almost 1000 presets.

I have to say that i asked E-mu support for help and i got an automatic answer from them with the name of 3 service center around the globe.
They dont provide support anymore, its a same.
Anyway Stu you an E-mu hero in this forum
analog1
 
Posts: 10
Joined: Tue May 19, 2009 10:00 pm


Return to EOS: The Knowledge