emusonacid! legacy
read-only snapshot at Apr 2014, see FAQ for details
to search emusonacid
use web search engine
use web search engine
Pops/clicks with ADAT connection
2 posts • Page 1 of 1
Pops/clicks with ADAT connection
by speak_onion » Sun Jun 05, 2011 5:08 pm
I have an E4 Platinum that I recently connected to my MOTU 828mk2 interface via ADAT cables. I'm getting some very quiet (but noticeable) clicks/pops along with the incoming audio. The pops/clicks are not present on the analog outputs. Is this a problem with the digital audio sync? If so, how can I correct it? I've never used the adat outputs on the E4 before, nor have I used the ADAT inputs on the 828 before. Any tips are greatly appreciated.
- speak_onion
- Posts: 17
- Joined: Wed Dec 22, 2010 3:37 pm
Re: Pops/clicks with ADAT connection
by MFPhouse » Mon Jun 06, 2011 9:23 am
...can be a digital Sync Problem.
If you connect your E-MU via Adat , you have to made your sync Settings in the Sytem Menu.
Don´t forget also to Plug the Adat "In" from the Emu with a PipeCable.( if your choice is the Adat as Sync ref )
If you connect your E-MU via Adat , you have to made your sync Settings in the Sytem Menu.
Don´t forget also to Plug the Adat "In" from the Emu with a PipeCable.( if your choice is the Adat as Sync ref )
- MFPhouse
- Posts: 323
- Joined: Mon Dec 06, 2004 11:11 pm
2 posts • Page 1 of 1