by sampleandhold » Fri May 09, 2003 12:47 am
okay okay okay... how about this then...
so you have that giant preset with all those samples in it. write down, or remember what ones you want. then clean out your preset so it is empty again. now what you are going to do is go back into your file manage bit, the part that you loaded that preset in the first place, you have to hit browse if i remember right. now what you want to do move the highlight on top of the preset with the samples in it. now it browse again, you should see a bit that says "samples" select that. what you will see now is a complete listing of all the samples in that preset. select those stabs or whatever it is you are after and load those. you will find that they will load in the empty sample bank, if i can remember right. once you get the ones you want. you are actually going to have to place them, and now that you have done that you can export or save the preset and now you have a preset that is just those samples.
sorry for the foggy explaination... if you don't follow me, then i will have to go and write the steps down, it is hard to remember, it is all second nature. i guess i spend too much time in the studio and not enough time out side.
i hope this helps you out man. i misunderstood you the first time, but now i think i have it sorted. post on this if it works, and of course post if it doesn't. but i think you are sorted.
"{jU$t-n3Rv0U$-N-+h3-@Ll3y-W@y}"