emusonacid! legacy

by **stevendubya** » Wed Aug 30, 2006 10:40 am

Greetings

I got a little logic sequence goin on but when I try to resample
one of the preset's settings dont seem to work ( the cords I have set up for lfo1 and 2). The preset plays but not as it should! it seems to ignore cords?
Is this normal?

If there is a simple answer excuse my ignorance as I haven't had sampler for too long, I did scour the site but didn't see anything relating to this.

Thanks in advance for any help

Steve

by **Randomguy** » Mon Sep 04, 2006 3:15 pm

im assuming its because you are no longer in multi mode - ie the sequencer is sending midi notes and the emu is playing them as if you were in the sample edit screen???

by **stevendubya** » Mon Sep 04, 2006 4:49 pm

not at all randomguy.
I am in multimode and 16 channels are playing back fine.
Its when I go to resample that ONE of the presets doesn't play properly.
The LFO's on a particular preset dont kick in as they do normally when I play the sequence.

doesn't anyone know the answer!?

thanks for your reply by the way

steve

by **Randomguy** » Mon Sep 04, 2006 5:04 pm

hmm thats odd

never tried resampling

will have a try at this when i get in later 8-)

emusonacid! legacy

Preset changes when I try to resample

Preset changes when I try to resample