emusonacid! legacy

by **gcoudert** » Thu Feb 08, 2007 1:27 pm

What is the 'highest' version of EOS I can run on my E4K?

My configuration:
64 voices
128Mb sample RAM
1Mb CPU RAM
1Mb Flash RAM
EOS 3.00b

Could I install v. 4.10 without requiring a hardware upgrade? I know I don't have enough flash RAM to run 4.62.

Thanks,

Gilles

by **sinewave** » Thu Feb 08, 2007 3:57 pm

Dear Gilles!

I'm not shure which is the highest EOS version you could run on your E4K, but for sure you can't upgrade to EOS 4.10. It also requires at least 2 MB of FLASH RAM. For more information, follow this link: http://www.emu.com/support/files/downlo ... =1&File=80

by **gcoudert** » Thu Feb 08, 2007 5:53 pm

What does the flash RAM upgrade involve exactly?

Is it just a matter of putting a card in a slot, like RAM, or does it involve soldering?

Thanks,

Gilles

by **groovebox** » Sun Apr 01, 2007 11:57 pm

It requires soldering. On the rack mount samplers it was a "clip in" chip (like a memory chip). On the E4K it is soldered.

by **kan** » Sat Apr 28, 2007 8:23 pm

Would you please tell me about the E-IV

I need to upgrade 'cause it came with EOS 1.03 and it takes forever to format a 4Go scsi drive
What do I need to upgrade to 2 Mo Flash ram?

Thanks for your help

by **nuts** » Sat Apr 28, 2007 10:17 pm

On my E6400 classic i upgraded from eos 3.00b to eos 4.62, i bought a 2MB CPU flashram and it didn't require soldering.
I only put it in the CPUram slot and follow the procedure for upgrading (don't remember exactly sorry).

The guy techtone sold this 2MB cpuram few months ago with eos 4.62 inside.

by **kan** » Sun Apr 29, 2007 12:28 am

COULD YOU HELP ME TO UPDATE MY E-IV WHICH CAME WITH EOS 1.03
WHEN I DOWNLOAD THE FILE THERE'S NO WAY TO BOOT WITH THE FLOPPY I MADE THE UNIT ALWAYS ASKS TO BOOT FROM THE FLASH RAM SO I CAN'T UPDATE THE EOS

by **JeffB63** » Mon Apr 30, 2007 6:04 pm

kan wrote:COULD YOU HELP ME TO UPDATE MY E-IV WHICH CAME WITH EOS 1.03
WHEN I DOWNLOAD THE FILE THERE'S NO WAY TO BOOT WITH THE FLOPPY I MADE THE UNIT ALWAYS ASKS TO BOOT FROM THE FLASH RAM SO I CAN'T UPDATE THE EOS

As I recall you need to use flashprep to upgrade from low numbered EOS versions.

by **kan** » Mon Apr 30, 2007 7:33 pm

OK
It works now EOS 3.00b is in my E-IV unit

Thanks again 4 you help
Best regards from Luxembourg

emusonacid! legacy

EOS

EOS

And what about the EIV

Tanks