RFX-32 not backwards compatible?!?

Any problems with your Ultra sampler should be reported here, hopefully someone might know what's wrong.

Moderators: ezman, stu, Ole

RFX-32 not backwards compatible?!?

Postby Flipped » Tue Sep 09, 2003 3:19 am

Hopefully this problem has happened to others in this forum and there is a simple solution. I have quite a few banks filled with presets that I can't seem to effect with the RFX card. Any bank I load off the SIGNATURE SERIES BUNDLE is impossible to effect. I can effect any preset in a new bank I create from scratch but not presets from existing banks. Has anyone else experienced this or am I just incredibly confused here? I use the exact same steps in both cases. The only time I can hear my old presets through any effects is when I am in the Master->FX->RSetup screen. Once I leave that screen the effects are gone and the signal runs dry even if I run the preset though the bus that has the effects on it. Any ideas? I am almost ready to use my RFX card as a book end so any help for this problem would be excellent. :???:
Flipped
 
Posts: 50
Joined: Mon Aug 25, 2003 6:01 pm
Location: Canada

Postby MindMech » Tue Sep 09, 2003 4:05 pm

You need to go into your voices and change them over from classic mode to RFX mode... It's all in the manual.
MindMech
 
Posts: 119
Joined: Sun Jul 06, 2003 3:52 am
Location: Somerville, MA

Postby Flipped » Wed Sep 10, 2003 8:20 pm

Thanks for your response MindMech but that wasn't the problem. The problem was that I was in Multimode and I had not updated the current Multisetup to the RFX setup I was using so I was using the default legacy effects. I swear I read the manual! I must have missed that. :grin: Thanks! I am up and running again! :slayer:
Flipped
 
Posts: 50
Joined: Mon Aug 25, 2003 6:01 pm
Location: Canada


Return to EOS:Troubleshooting