by Klaseed » Wed Sep 10, 2003 9:41 pm
If I understand what you want to do correctly, this is how you do it:
In your voice, for Cord 1, set up Cord 1 like this: LFO1~->FiltFreq-'x', where x will be the maximum amount of LFO modulation applied when Aux env is at it's peak.
For Cord 2, set source as AuxEnv, destination as C01 (Emu-speak for Cord 1) and amount at +100.
Now, the amount of LFO applied to the filter should rise and fall according to Aux Env.
Note that if Aux Env never reaches a level of 127, or if Cord 2 amount is less than 100, Aux Env won't affect the LFO amount as much. But, the settings above provide a good starting point, and should make the effect pretty audible.
"It doesn't work, and neither do we"
WTB: Digital option board for my Ultra :)
sorry bout the title but say i want to control the amount of LFO I am allowing to control the filter by Aux Env. Is this possible? What about the other way round. I just can't seem to get a proper destination in the ol' cords section 
It must be possible....
Thanks man, I always wondered what the CO thingies were - the answer was right in front of me 
