E6400 ultra problem

Any problems with your Ultra sampler should be reported here, hopefully someone might know what's wrong.

Moderators: ezman, stu, Ole

E6400 ultra problem

Postby sebprada » Thu Mar 10, 2011 11:03 am

Hi all,

It's my first post on this board....but it's for a problem :)
I've recently bought an e6400 ultra with 128mo RAM, Adat card, Zip scsi, IDE hard drive...
The sampling section is ok, i can sample a sound, place him in a preset etc.... but when i try to save the preset on the hard drive or the zip, i get a "Fatal Error : Gen Trap error......" . Same for save a sample. I can't save something.
The only way to save is by the floppy drive.
I tried to reinstall the EOS 4.7, and after the 4.61. Nothing.
I bought new 2x 64 mo RAM EDO. The hard drive is new. Nothing happened.
I searched on the net, without success. PLease, can you help me ?
See the picture for the "Fatal error".
Thnks lot !!!!
Attachments
photo.JPG
photo.JPG (63.54 KiB) Viewed 731 times
sebprada
 
Posts: 3
Joined: Thu Mar 10, 2011 10:49 am

Re: E6400 ultra problem

Postby sebprada » Sat Mar 12, 2011 9:20 am

No ideas ?
sebprada
 
Posts: 3
Joined: Thu Mar 10, 2011 10:49 am

Re: E6400 ultra problem

Postby kalide » Mon Mar 14, 2011 6:19 am

Try saving to the floppy to eliminate the hard drives.

Do you have more than one SCSI device connected ?
's'allbollocksinnit.
kalide
 
Posts: 267
Joined: Tue Nov 21, 2006 3:11 am
Location: Boston, MA

Re: E6400 ultra problem

Postby sebprada » Mon Mar 14, 2011 10:25 am

Hi,

thanx for the reply. If i use the e6400, i want to use it with IDE hard drive or zip. but not with the floppy drive....
I have just one zip scsi. But now, he's not connected.
sebprada
 
Posts: 3
Joined: Thu Mar 10, 2011 10:49 am

Re: E6400 ultra problem

Postby MFPhouse » Mon Mar 14, 2011 10:26 am

Can be also the Sleep-Modus. There are two . One for the System and one for the Hard-Disk.
If you build in a newer Scsi Devise , it can be that the Pin are lost or not supported. ( Sleep ).
MFPhouse Music at Last.fm, Facebookand Youtube
MFPhouse
 
Posts: 323
Joined: Mon Dec 06, 2004 11:11 pm

Re: E6400 ultra problem

Postby mosrob » Mon Mar 14, 2011 8:44 pm

If it is the Sleep-mode as MFPHouse assumes then enter DISK/BROWSE, remount drives and try to get the Info of your HD you want to save the bank to. This should disable the Sleep-mode.
IF this works, try to save your bank immediately to your HD.

Of course you should also try another HD to check if the error is related to the HD or to the EMU.
mosrob
 
Posts: 289
Joined: Thu Mar 04, 2010 11:32 pm
Location: Dortmund (Germany)


Return to EOS:Troubleshooting