Btw thanks kalide your ace
yeah i put it as fat 32 (done in osx's terminal)
Came up on mac n pc as fat 32 drive.
I had an ultra (quantum) drive in the emu, taken it out now.
As the adddonic drive takes a standard molex power cable, i flipped the positive n negative.
The addonic drive powers up but is not seen by the sampler.
After trying every single jumper combination (it was already factory set as a master via the jumpers),
i got annoyed and flipped the molex cable around. To my surprise, the LED on the hard drive still lit up. I was silly to do so but in the heat of the moment i was very annoyed.
heres an image of the probelms i have
[img]http://www.picoodle.com/view.php?img=/3/2/8/f_Untitled1m_2d65dc7.jpg&srv=img32][img]http://img32.picoodle.com/img/img32/3/2/8/f_Untitled1m_2d65dc7.jpg[/img]
problem one is that it says 5v on the drive but the sampler is pulling out 6. something
problem two is what i was trying to say before, and i think its a problem causing the machine not to read my drive
it goes from ide large top of the enclosure to usib
which is the connection shown in problem two
to ide small on the left picture down the bottom
what to do my friend :-S